Your browser is not supported

Stai utilizzando un browser che non è più supportato. Per continuare a visitare il nostro sito Web, scegli uno dei seguenti browser supportati.


Condensable vapours, such as water vapour, can be easily handled by a modern laboratory vacuum pump, provided that an effective pumping protocol is followed to allow the water to remain in vapour phase within the pump.

This applies to both oil sealed pumps and dry pumps

Possible drawbacks of condensable vapours in a vacuum pump

Allowing vapour to condense inside the pump will result in:

  • Performance degradation
  • Failure to achieve ultimate
  • Slow pump-down
  • Cause mechanical problems.

Not following a good pumping protocol will mean a very long time to pump down to target pressures. Once vapour condenses inside a vacuum pump it can lead to reduced reliability via accelerated corrosive effects; condensation can also increase pump-down times and limits ultimate pressures.

Edwards RV rotary vane pump with accessories

Edwards RV rotary vane pump with accessories

  1. Mist filter
  2. Gas ballast oil return
  3. Vibration isolator
  4. Foreline trap 
  5. Cables

How to avoid the drawbacks of condensable vapours?

1. Warm up your pump before exposing it to condensable vapour

Firstly it is important for the pump to warm-up to its normal operating temperature before exposing it to condensable vapour, this will typically take up to 60 minutes. This will prevent water vapour condensing inside the relatively cool pump.

“Blanking” the inlet of the pump, by closing a valve, and allowing the pump to run pumping “nothing” is all that is required. 

Running gas ballast during this process will help the pump warm up faster.

2. Run a gas ballast while pumping vapours

Secondly the ballast should generally be run all the time that vapour is being passed through the pump.

While the vapour being pumped is saturated, the vacuum pump’s ultimate pressure will be limited, not by ultimate pressure performance of the pump itself, but by the vapour pressure of the material being processed. For example, water has a saturated vapour pressure of ~24 mbar (18 Torr) at 20 °C (70 °F), this is the best pressure the pump can achieve until all the water has been pumped away.

Allowing water vapour to condense inside a pump will make the time to recover ultimate pressure much longer than if it remains in vapour phase because it has to be re-evaporated before it can be pumped out. Condensed water can reduce oil sealed rotary vane oil lifetime and in all pumps condensed vapour can ‘accelerate’ corrosive effects of other materials being processed.

Gas Ballast control on RV oil sealed rotary vane pump

Gas Ballast control on RV oil sealed rotary vane pump

3. Allow your pump to “clean up” after pumping vapours

Allowing the pump to “clean up” after pumping vapours will extend pump life and performance.

If the pump is switched off as soon as the procedure producing vapour is finished, vapour will remain inside the pump, condense and lead to accelerated wear by allowing the inside of the pump to corrode. Running the pump with the inlet “blanked off” with a valve will allow the pump to exhaust any residual vapours will give the longest life and fastest recovery when it is used next. 

It is recommended the pump is run for a minimum of 20 to 30 minutes after finishing the vacuum process as best practice. Running gas ballast during “clean up” will ensure that the condensable vapours are expelled from the pump. Very importantly when pumping potentially flammable vapours inert gas such as nitrogen should be used as the ballast gas.

Download the complete application note

Application notes PDF download

By submitting this request, Edwards Vacuum will be able to contact you through the collected information. More information can be found in our privacy policy.
Edwards employee s standing in corridor smiling