Your browser is not supported

더 이상 지원하지 않는 브라우저를 사용하고 있습니다. 저희 웹 사이트를 계속 방문하려면 다음 지원되는 브라우저 중 하나를 선택하십시오.


What is a gas ballast?

Gas ballast is a constructional feature widely applied in many primary vacuum pumps for the pumping of vapours.

Wolfgang Gaede invented the gas-ballast principle in 1935 and was originally focussed on primary oil sealed pumps. Gas ballast is useful in reducing the extent of vapour contamination in the oil (and/or other parts) thus extending oil life and at a more fundamental level permitting the pump to operate on vapour duty at nearly full specifications.

Put simply, depending on the percentage make-up of vapour in the pumped load, then without gas ballast the pump can ‘stagnate’.

A typical physical representation of the gas ballast configuration is shown below:

Typical physical representation of the gas ballast configuration

  1. Gas and vapour
  2. Gas ballast flow
  3. Gas
  4. Liquid droplets (from condensed vapour) – no gas ballast

Red: Vapour

Purple: Gas

How does a gas ballast work?

The basic principle of ballast is that atmospheric air (or CDA or inert gas) is admitted into a pump during the (late) compression stages (as above).

This increases the percentage of non-condensable gas such that the partial pressure of the vapour being pumped is below its saturated vapour pressure when the exhaust valve opens (typically at a pressure of 1.05 to 1.2 bara). This means that the vapour is discharged from the pump without liquefaction.

The work performed from ballasting tends to increase the operating temperature which again helps with vapour handling.

Download the complete application note

Application notes PDF download

By submitting this request, Edwards Vacuum will be able to contact you through the collected information. More information can be found in our privacy policy.
Edwards employee s standing in corridor smiling